I'm embarrassed to admit this but ever since I've owned my SC20 (about 20 years now) the tiller crossbar has been a 10' stick of 3/4" EMT conduit... It needs replacing and I'm curious what the proper diameter and wall thickness was supposed to be. Can someone measure theirs?
Thanks,
Eric
Tiller Crossbar
Re: Tiller Crossbar
I can't get that for you since my computer is down and maybe permanently. I did have to chuckle though. I owned a SC19 for 10 years and am still not sure about the shroud extenders(not the hyfield levers) ..as when do you use them?
-
Eric2101
- Professional
- Posts: 205
- Joined: August 16th, 2004, 5:42 am
- Boat Make/Model: Supercat 15
- Location: Davie, FL.
Re: Tiller Crossbar
The tiller crossbar on the ARC 21 is a 3 piece assmbly. AS seen below.
---------=====---------
The 2 outer peices slide into the middle peice and are held into place with stainless set screws. This arrangement gives you room to calibrate your toe.
Eric 2101
ARC2101
---------=====---------
The 2 outer peices slide into the middle peice and are held into place with stainless set screws. This arrangement gives you room to calibrate your toe.
Eric 2101
ARC2101
Eric Arbogast
Supercat 15
Supercat 15
Re: Tiller Crossbar
Do you happen to have a picture? Any idea what the OD and wall thickness is of the outer pieces? I'm guessing it is 1" but I'm trying to see how much wall thickness I want.
-
Eric2101
- Professional
- Posts: 205
- Joined: August 16th, 2004, 5:42 am
- Boat Make/Model: Supercat 15
- Location: Davie, FL.
Re: Tiller Crossbar
sorry I have not reponded. I'll get out there and measure soon.
Eric Arbogast
Supercat 15
Supercat 15