SC20TR mast straighten attempt
Posted: February 12th, 2004, 7:57 am
Good Morning,
This winter I have been attempting to straighten my mast, (SC20TR with the “tri-spreader” configuration).
Quick History: The previous owner was attempting to compensate for the bend with loading the wires on one side. This condition did not allow the mast to “flop-over” on Port.
I currently have all wires loosened and the mast cradled in a position to correct the bend.
A quick question(s) on diamond wire tensions and pre-bend for my mast:
1) Does this mast lend itself “happily” to pre-bend?
a. I have two sets of main sails:
i. One original cut pin head
ii. And one high aspect square top Smyth SC22 main
2) What wire tension specifications should I be shooting for?
3) Am I missing important steps in my attempt here?
In Conclusion: Should I be looking to upgrade my stick, or should this stick still have some life at this age?
Help Please…..
Bobby
This winter I have been attempting to straighten my mast, (SC20TR with the “tri-spreader” configuration).
Quick History: The previous owner was attempting to compensate for the bend with loading the wires on one side. This condition did not allow the mast to “flop-over” on Port.
I currently have all wires loosened and the mast cradled in a position to correct the bend.
A quick question(s) on diamond wire tensions and pre-bend for my mast:
1) Does this mast lend itself “happily” to pre-bend?
a. I have two sets of main sails:
i. One original cut pin head
ii. And one high aspect square top Smyth SC22 main
2) What wire tension specifications should I be shooting for?
3) Am I missing important steps in my attempt here?
In Conclusion: Should I be looking to upgrade my stick, or should this stick still have some life at this age?
Help Please…..
Bobby