Search found 504 matches
- August 9th, 2005, 8:43 pm
- Forum: General Discussion
- Topic: sail swap
- Replies: 1
- Views: 3599
Hello, I don't have the numbers in front of me right now but I think the mainsail on a SC19XL is the same size or just slightly smaller then the standard rig on the SuperCat20. The mast on both boats were 33' but the SC20 had a boom and I think the foot was slightly longer (maybe an inch or two) the...
- July 20th, 2005, 11:22 pm
- Forum: General Discussion
- Topic: Windward sheeting??
- Replies: 4
- Views: 6222
Dave, A well maintained Wire Traveler car works just fine, but the Harken system is much nicer and will probably roll from side to side better. The cable traveler was originally used on the SC20 to allow for the telescopic feature. As a result all of the SuperCat products utilized the cable traveler...
- July 12th, 2005, 10:25 pm
- Forum: General Discussion
- Topic: Windward sheeting??
- Replies: 4
- Views: 6222
- July 12th, 2005, 10:22 pm
- Forum: Technical Forum
- Topic: SC20 Main Halyard
- Replies: 28
- Views: 33669
Eric, You could be right about the two problems being related. The halyard hook is not supposed to be centered on the sail track, it is slightly off to one side. The halyard rope, when pulled straight down the mast, should pass the hook without touching. It should be close, but not touching. There s...
- July 12th, 2005, 10:16 pm
- Forum: Technical Forum
- Topic: SC20 roller furler swivel
- Replies: 2
- Views: 4789
- July 7th, 2005, 8:37 pm
- Forum: General Discussion
- Topic: DAMN! the Just lost the starbord shroud again!
- Replies: 3
- Views: 5081
Rob, It sounds like the swager you used was out of calibration. For the wire length you can either measure your exsisting wire or call Aquarius Sail and we can make up a new set that are to the original specs for your boat. With regards to the slack in the leward stay. Yes there should be some slack...
- June 25th, 2005, 8:26 am
- Forum: General Discussion
- Topic: A New Owner of an Old Supercat 17
- Replies: 2
- Views: 4438
SailorRory, Congratulations on your boat! All of the parts and manuals for your boat are available from Aquarius Sail. You can contact us via email at sales@aquarius-sail.com or via telephone at 651-462-SAIL. If you have any questions about the boat please feel free to post them here on the forums a...
- May 18th, 2005, 10:14 pm
- Forum: Technical Forum
- Topic: SC20 decks
- Replies: 14
- Views: 15183
- May 18th, 2005, 6:55 pm
- Forum: Technical Forum
- Topic: SC20 decks
- Replies: 14
- Views: 15183
- May 12th, 2005, 7:01 pm
- Forum: Technical Forum
- Topic: SC20 decks
- Replies: 14
- Views: 15183
- May 10th, 2005, 8:19 pm
- Forum: Technical Forum
- Topic: SC20 decks
- Replies: 14
- Views: 15183
Dan, Even as early as 1980 the new mold was being used without the deck plates, and being that your boat is a 1981 it is pretty late to still have the full deck plate, but I suppose it is not impossible. With regards to the cut-out by the daggerboard trunk, The newer boats without the full deck plat...
- April 28th, 2005, 12:34 pm
- Forum: Technical Forum
- Topic: SC20 decks
- Replies: 14
- Views: 15183
Dan, How old is your SC20. The very early SC20's did have full deck plates between the forward and aft beams along with a deck plate running from the forward beam up towards the bridle wire tang. These decks were installed after the hull was removed from the mold and the bulkheads and daggerboard tr...
- April 21st, 2005, 3:45 pm
- Forum: Technical Forum
- Topic: Dull Hulls - How can I Shine Them Up? Poli-Glow?
- Replies: 1
- Views: 4185
- April 21st, 2005, 2:51 pm
- Forum: Technical Forum
- Topic: Mast rake
- Replies: 5
- Views: 7551
- April 20th, 2005, 10:08 pm
- Forum: Technical Forum
- Topic: Mast rake
- Replies: 5
- Views: 7551