Aquarius Sail Owners

I asked either Matt or Tom one time about the tightness. They told me something about using a bungy cord wrapped around the wires to check them. I can't remember exaclty what they said. Maybe one of them can write something up about it.

I am wondering myself. How is your righting line set up? Does it come from inside the hull or is it over the hull when you are righting?

I had mine com from the inside corner of the hull.

How long did it take to get it up?

Looking for some opinions. I have only flipped my SC-20 twice. When it seems that when I am on the verge of going over I simultaneously dump the traveler or mainsheet and turn into the wind. If I am too close I end up going over. It seems with the turn into the wind it accelerates the boat going ove...

I would like to put a couple of foot straps on the sides of each hull. I am pretty sure that it would be mounted over a foam cored portion of the hull. I am thinking the best way to do this to grind a 2 inch diameter circle through the outer layer of glass and through the foam core without damaging ...

I think I am going to put an access port on each transom between the rudder gudgeons. This will allow access to the inside to lay a little more fiberglass in there. Since the fiberglass is so thin where it would be installed I don't think it would cause a loss of strength. It would also be good for ...

Is the 1/16" toe in the same on the SC-20?

Matt, I did flip my SC20 in >15 knot winds one time and with the upper shroud extended and the wind helping blow us over it did take a good effort with three of us (about 480#'s) to get the boat back up. We had the sheets released and I am pretty sure that the mast did not leak. The three of us were...

Thanks Matt. I have thought about that also. Would you recommend doing that instead of putting a track system down? What kind of range would you make these points? Is this an adjustment you make once and leave it there for sailing different points? I am still doing fiberglass work on my hulls and it...

I have a SC20 and am thinking about putting some kind of track system on each hull so I can move the jib blocks fore and aft.

Has anyone else done something like this?

Did you ever get any info on doing this? I am curious also.

Can't help you with the conversion but thought I would show you my cracks. You think yours are bad.

They went 2/3rds the way around. I think I got all the use out of them I could.