Page 1 of 1

Compression dings in hulls

Posted: October 8th, 2020, 11:23 am
by gahamby
In the course of cleaning and polishing the hulls I noticed a compression ding on the outboard side of the port hull up forward where I think the bulkhead is. It's rectangular in shape and vertically oriented. I've tried getting a picture but it doesn't read on camera. Is this a structural problem or just cosmetic?

Re: Compression dings in hulls

Posted: October 8th, 2020, 8:10 pm
by Matt Haberman
I suspect it is probably just cosmetic. If it is rectangular and vertical I am guessing it is actually a "silhouette" of the bulkhead caused by the foam shrinking as it cured.

Re: Compression dings in hulls

Posted: October 19th, 2020, 12:10 pm
by gahamby
Thanks for the reply. I figured as much. I had finally gotten her shiney enough to notice.