Compression dings in hulls

Technical discussion of ARC products
Post Reply
gahamby
Professional
Posts: 252
Joined: July 24th, 2012, 7:02 am
Boat Make/Model: SuperCat 15#315
Location: Falls Church VA 22042

Compression dings in hulls

Post by gahamby »

In the course of cleaning and polishing the hulls I noticed a compression ding on the outboard side of the port hull up forward where I think the bulkhead is. It's rectangular in shape and vertically oriented. I've tried getting a picture but it doesn't read on camera. Is this a structural problem or just cosmetic?
Matt Haberman
Administrator
Posts: 601
Joined: November 10th, 2003, 8:22 pm
Location: Minnesota
Contact:

Re: Compression dings in hulls

Post by Matt Haberman »

I suspect it is probably just cosmetic. If it is rectangular and vertical I am guessing it is actually a "silhouette" of the bulkhead caused by the foam shrinking as it cured.
Matt Haberman
Aquarius Sail Inc.
http://www.aquarius-sail.com
gahamby
Professional
Posts: 252
Joined: July 24th, 2012, 7:02 am
Boat Make/Model: SuperCat 15#315
Location: Falls Church VA 22042

Re: Compression dings in hulls

Post by gahamby »

Thanks for the reply. I figured as much. I had finally gotten her shiney enough to notice.
Post Reply