To keep my SC20 at the marina (which means I will sail it much more than trailering it) I have had to change its width to 10 feet from 12 feet. What toe in (if any) should I use to set the huls up at their new width. When I got the boat at its 12 foot width there was substantial toe in of the hulls (3.5 inches at least).
Thanks Matt,
Will adjust accordingly.
If I loosen the Allen key bolts at the corners where the crossbars attach to the hulls can I fine tune the toe in from there, or are they not adjustable at that point?
At the bottom of each saddle are 2 locating pins (allen screw heads) and a corresponding hole in the beam which prevent the beams moving inside the saddles.
Maybe yours got pushed in if the were not initially aligned correctly when the bolts were tightened.